Rohde & Schwarz RTP Series - Starting and Stopping Acquisition

Remote control commands
R&S
®
RTP
1187User Manual 1337.9952.02 ─ 12
To prevent an overlapping execution of commands, one of the commands *OPC,
*OPC? or *WAI can be used after the command or a command set.
For more information, see:
●
www.rohde-schwarz.com/rc-via-scpi, chapter "Command Sequence and Synchro-
nization"
●
Chapter 22.3, "Programming examples", on page 1126
● Starting and stopping acquisition........................................................................ 1187
● Time base............................................................................................................1188
● Acquisition...........................................................................................................1194
● Fast segmentation...............................................................................................1198
● Vertical.................................................................................................................1199
● Waveform data....................................................................................................1204
● Probes.................................................................................................................1206
● R&S RT-ZVC probe.............................................................................................1230
● Differential signals...............................................................................................1243
● Digital filter.......................................................................................................... 1247
● Skew................................................................................................................... 1247
● AUX OUT............................................................................................................ 1249
● High definition mode........................................................................................... 1250
● Reference clock.................................................................................................. 1251
22.8.1 Starting and stopping acquisition
RUNContinous.............................................................................................................1187
RUN........................................................................................................................... 1187
RUNSingle.................................................................................................................. 1187
SINGle........................................................................................................................1187
STOP..........................................................................................................................1188
RUNContinous
RUN
Starts the continuous acquisition.
Usage:
Event
Asynchronous command
RUNSingle
SINGle
Starts a defined number of acquisition cycles. The number of cycles is set with
ACQuire:COUNt.
Usage:
Event
Asynchronous command
Acquisition and setup