Rohde & Schwarz RTP Series - Diagnostic Remote Trace Commands; Deprecated Commands

Remote control commands
R&S
®
RTP
2314User Manual 1337.9952.02 ─ 12
22.26.2 Diagnostic remote trace commands
TRACe:REMote:MODE:FILE:DEXecution:DURation........................................................2314
TRACe:REMote:MODE:FILE:RPC.................................................................................2314
TRACe:REMote:MODE:FILE:PARSer............................................................................ 2314
TRACe:REMote:MODE:FILE:FUNCtions........................................................................2314
TRACe:REMote:MODE:FILE:DEXecution:DURation <Enable>
Traces the device execution time of a command
Parameters:
<Enable> ON | OFF
TRACe:REMote:MODE:FILE:RPC <Enable>
Enables and disables output of rpc calls to remote trace.
Parameters:
<Enable> ON | OFF
TRACe:REMote:MODE:FILE:PARSer <Enable>
Enables and disables output of parser transitions to remote trace.
Parameters:
<Enable> ON | OFF
TRACe:REMote:MODE:FILE:FUNCtions <Enable>
Enables and disables output of function names to remote trace.
Parameters:
<Enable> ON | OFF
22.27 Deprecated commands
The following commands are provided for compatibility to previous oscilloscope ver-
sions only. For new remote control programs, use the specified alternative commands.
Deprecated commands