Rohde & Schwarz RTP Series - DC Offset Alignment

Waveform generator (Option R&S RTP-B6)
R&S
®
RTP
978User Manual 1337.9952.02 ─ 12
Remote command:
WGENerator<m>:MODulation:NOISe on page 2237
Relative level
Sets the level of the noise in percentage of the set "Amplitude" output of the signal.
Remote command:
WGENerator<m>:MODulation:NLPCent on page 2237
Absolute level
Displays the level of the noise in volts.
Remote command:
WGENerator<m>:MODulation:NLABsolute? on page 2237
Absolute level
For "Function type">"DC" only.
Sets the level for the DC signal.
Remote command:
WGENerator<m>:MODulation:NDCLevel on page 2237
15.3.3 DC offset alignment
Access: [Gen] > "Output" > "Align DC Offset"
Start Alignement
Starts the alignment of the DC offset.
Remote command:
GENerator:ALIGnment:DC[:STARt] on page 2239
Date
Displays the date of the last performed DC offset alignment.
Output