Rohde & Schwarz RTP Series - Savesets and One File

Remote control commands
R&S
®
RTP
1524User Manual 1337.9952.02 ─ 12
<FileName> String parameter specifying the complete path and filename of
the source file.
Example:
*SAV 4
MMEM:STORe:STATe 4,'C:
\Settings\Settings_1051.dfl'
Saves current instrument settings to the internal memory num-
ber 4. Then stores the settings from the internal memory number
4 to the file C:\Settings\Settings_1051.dfl.
Usage: Setting only
MMEMory:LOAD:STATe
<MemoryNumber>, <FileName>
Loads the instrument settings from the specified file to the specified internal memory.
After the file has been loaded, the settings must be activated using a *RCL command.
Setting parameters:
<MemoryNumber> Number of the internal memory
Range: 1 to 99
<FileName> String parameter specifying the complete path and filename of
the source file.
Example:
MMEM:LOAD:STATe 4,'C:
\Settings\Settings_1051.dfl'
*RCL 4
Loads instrument settings from the file
C:\Settings\Settings_1051.dfl to the internal memory
number 4, and then activates the settings in internal memory
number 4.
Usage: Setting only
22.16.2 Savesets and one file
SAVeset:CONFig:PREView...........................................................................................1524
SAVeset:ONEFile:NAME...............................................................................................1525
SAVeset:ONEFile:OPEN...............................................................................................1525
SAVeset:ONEFile:SAVE................................................................................................1525
SAVeset:CONFig:PREView <Include>
If set to OFF, the saveset is stored without the preview image to reduce the file size.
Use the command each time before you save a saveset.
Parameters:
<Include> ON | OFF
*RST: ON
Data management