Rohde & Schwarz RTP Series - Components

Remote control commands
R&S
®
RTP
2296User Manual 1337.9952.02 ─ 12
DEEMbedding<m>:OPEN
Opens and loads the deembedding configuration from the file specified with
DEEMbedding<m>:NAME.
Suffix:
<m>
.
1..4
Selects the channel that is configured for deembedding.
Usage: Event
DEEMbedding<m>:DELete
Deletes the deembedding configuration file specified with DEEMbedding<m>:NAME.
Suffix:
<m>
.
1..4
Selects the channel that is configured for deembedding.
Usage: Event
22.23.3 Components
● General settings..................................................................................................2296
● DUT settings....................................................................................................... 2298
● R&S RT-ZM probe settings................................................................................. 2299
● Cable, adapter, fixture and custom settings........................................................2300
22.23.3.1 General settings
DEEMbedding<m>:COMPonent<n>[:STATe] <IsEnabled>
Enables or disables the indicated component for deembedding.
The first and the last component are always enabled and cannot be disabled.
Suffix:
<m>
.
1..4
Selects the channel that is configured for deembedding.
<n> 2..n-1
Index of the component in the measurement setup. The DUT
has index 1, the probe has index n.
Parameters:
<IsEnabled> ON | OFF
*RST: OFF
Usage: Asynchronous command
Deembedding (Option R&S RTP-K121/-K122)