Getting started
R&S
®
RTP
40User Manual 1337.9952.02 ─ 12
3 Getting started
Note: the following chapters are identical to those in the R&S RTP Getting Started
manual for R&S RTP instruments.
● Preparing for use.....................................................................................................40
● Instrument tour........................................................................................................47
● Operating the instrument.........................................................................................61
3.1 Preparing for use
Here, you can find basic information about setting up the instrument for the first time or
when changing the operating site.
3.1.1 Lifting and carrying
See: "Lifting and carrying the instrument" on page 28.
3.1.2 Unpacking and checking
1. Unpack the product carefully.
2. Retain the original packing material. Use it when transporting or shipping the prod-
uct later.
3. Using the delivery notes, check the equipment for completeness.
4. Check the equipment for damage.
If the delivery is incomplete or equipment is damaged, contact Rohde & Schwarz.
3.1.3 Choosing the operating site
Specific operating conditions ensure proper operation and avoid damage to the prod-
uct and connected devices. For information on environmental conditions such as ambi-
ent temperature and humidity, see the data sheet.
See also "Choosing the operating site" on page 28.
Electromagnetic compatibility classes
The electromagnetic compatibility (EMC) class indicates where you can operate the
product. The EMC class of the product is given in the data sheet under "General data".
●
Class B equipment is suitable for use in:
– Residential environments
Preparing for use
To Next Page
Loading...
