Rohde & Schwarz RTP Series - Peak Search Using Cursors

Remote control commands
R&S
®
RTP
1358User Manual 1337.9952.02 ─ 12
CURSor<m>:YDELta:SLOPe <DeltaSlope>
Returns the inverse value of the voltage difference - the reciprocal of the vertical dis-
tance of two horizontal cursor lines: 1/
Δ V.
Suffix:
<m>
.
1..4
Selects the cursor set.
Parameters:
<DeltaSlope> Range: -100E+24 to 100E+24
Increment: 0
*RST: 0
Usage: Asynchronous command
22.11.3 Peak search using cursors
CURSor<m>:FFT:SETCenter........................................................................................ 1358
CURSor<m>:FFT:TOCenter.......................................................................................... 1358
CURSor<m>:MAXimum[:PEAK].....................................................................................1358
CURSor<m>:MAXimum:LEFT.......................................................................................1359
CURSor<m>:MAXimum:RIGHt......................................................................................1359
CURSor<m>:MAXimum:NEXT...................................................................................... 1359
CURSor<m>:FFT:SETCenter
Sets the center frequency to the frequency value that is measured at cursor line c1.
Suffix:
<m>
.
The suffix is irrelevant.
Usage: Event
Asynchronous command
CURSor<m>:FFT:TOCenter
Sets the vertical cursor line c1 to the center frequency.
Suffix:
<m>
.
The suffix is irrelevant.
Usage: Event
Asynchronous command
CURSor<m>:MAXimum[:PEAK]
Sets both cursors to the absolute peak value.
Suffix:
<m>
.
1..4
Selects the cursor set.
Cursor measurements