Rohde & Schwarz RTP Series - Starting and Stopping Remote Control

Network operation and remote control
R&S
®
RTP
1108User Manual 1337.9952.02 ─ 12
"INT8"
Signed integer data with length 8 bit.
"INT16"
Signed integer data with length 16 bit. The Byte order can be set
using .
For details on the formats, refer to the description of the remote com-
mand.
Remote command:
FORMat[:DATA] on page 1154
Byte order
Sets the endianess for INT16 data:
●
LSB first: little endian, least significant byte first
●
MSB first: big endian, most significant byte first
Remote command:
FORMat:BORDer on page 1155
Bit pattern format
Sets the format for all bit pattern queries.
Remote command:
FORMat:BPATtern on page 1155
SCPI logging
If enabled, all received remote commands are written into a text file. Enter the path and
filename with extension (log, txt, or csv) in "Log file path".
21.5.3 Starting and stopping remote control
21.5.3.1 Starting a remote control session
When you switch on the instrument, it is always in manual operation state ("local"
state). It can be operated via the front panel, the touch screen and external keyboard
and/or mouse.
► To start remote control:
● Send a command from the controller.
● VXI-11 protocol (LAN or USB interface): Use &GTR interface message.
While remote control is active, the instrument settings are optimized for maximum
measurement speed; the display is switched off. Operation via the front panel is dis-
abled.
On the touch screen, two buttons appear in the upper left corner: "Local" and "View".
Remote control