Protocol analysis
R&S
®
RTP
746User Manual 1337.9952.02 ─ 12
with eventual Manchester coding violations. In these situations, a fixed "Bit Rate" set-
ting has to be provided by the user to bypass the software's estimation algorithm.
13.15.2 Custom: Manchester / NRZ configuration
If you need information on how to get started with configuring the custom serial bus
setup, see Chapter 13.15.2.6, "Configuring custom Manchester / NRZ signals",
on page 763. Otherwise proceed with the configuration settings.
13.15.2.1 Custom: Manchester / NRZ configuration settings
Access: [Protocol] > "Setup" tab > "Protocol" = Custom
Make sure that the tab of the correct serial bus is selected.
Figure 13-17: Coding standard selection in the serial bus protocol configuration dialog
See also: Chapter 13.1.1, "Setup - general settings", on page 512
Coding Standard
To define the coding of the custom serial bus to be analyzed, select one of the follow-
ing standards:
Custom: Manchester / NRZ (option R&S
RTP-K50)M
To Next Page
Loading...
