Rohde & Schwarz RTP Series - Trigger; Basic Trigger Settings

Remote control commands
R&S
®
RTP
1252User Manual 1337.9952.02 ─ 12
22.9 Trigger
Some of the commands in the following chapter are asynchronous. An overlapping or
asynchronous command does not automatically finish executing before the next com-
mand starts executing. If overlapping commands must be executed in a defined order,
e.g. to avoid wrong measurement results, they must be serviced sequentially.
To prevent an overlapping execution of commands, one of the commands *OPC,
*OPC? or *WAI can be used after the command or a command set.
For more information, see:
●
www.rohde-schwarz.com/rc-via-scpi, chapter "Command Sequence and Synchro-
nization"
●
Chapter 22.3, "Programming examples", on page 1126
● Basic trigger settings...........................................................................................1252
● Edge trigger.........................................................................................................1256
● Glitch trigger........................................................................................................1259
● Width trigger........................................................................................................1260
● Runt trigger......................................................................................................... 1261
● Window trigger.................................................................................................... 1264
● Timeout trigger.................................................................................................... 1266
● Interval trigger..................................................................................................... 1267
● Slew rate trigger..................................................................................................1269
● Setup & Hold.......................................................................................................1271
● State trigger.........................................................................................................1273
● Pattern trigger..................................................................................................... 1273
● High-speed serial pattern trigger (option R&S RTP-K140/K141)........................1276
● TV/Video trigger.................................................................................................. 1295
● Line trigger.......................................................................................................... 1300
● Trigger qualification.............................................................................................1300
● Holdoff.................................................................................................................1303
● Conditioning........................................................................................................ 1307
● Trigger sequence................................................................................................ 1309
● Trigger control..................................................................................................... 1313
● Actions on trigger................................................................................................ 1314
● Zone trigger (option R&S RTP-K19)................................................................... 1316
● External trigger input...........................................................................................1317
● Acquisition info....................................................................................................1317
22.9.1 Basic trigger settings
TRIGger<m>:SOURce[:SELect].....................................................................................1253
TRIGger<m>:TYPE......................................................................................................1254
TRIGger<m>:EVENt.....................................................................................................1254
TRIGger<m>:LEVel<n>[:VALue].................................................................................... 1255
TRIGger<m>:FINDlevel................................................................................................ 1255
DISPlay:TRIGger:LINes................................................................................................1255
Trigger