Rohde & Schwarz RTP Series - Page 1421

Remote control commands
R&S
®
RTP
1421User Manual 1337.9952.02 ─ 12
Suffix:
<m>
.
1..10
See "Selection of the measurement group: MEASurement<m>"
on page 1359.
Parameters:
<FrameName>
MEASurement<m>:PROTocol:SBITrate:VAL <SecondaryBtRateIdVal>
Sets the field value of the frame for the secondary bit rate protocol measurement.
Suffix:
<m>
.
1..10
See "Selection of the measurement group: MEASurement<m>"
on page 1359.
Parameters:
<SecondaryBtRateIdVal>
Usage: Asynchronous command
MEASurement<m>:PROTocol:T2FRame:DIRection <TrigFrmDirct>
Sets the direction of the field for trigger to frame protocol measurement.
Suffix:
<m>
.
1..10
Parameters:
<TrigFrmDirct> T2F | F2T
T2F: trigger to frame
F2T: frame to trigger
*RST: T2F
Usage: Asynchronous command
MEASurement<m>:PROTocol:T2FRame:FLD <FieldName>
Sets the type of the field for trigger to frame protocol measurement.
Suffix:
<m>
.
1..10
Parameters:
<FieldName>
MEASurement<m>:PROTocol:T2FRame:FRM <FrameName>
Sets the value of the frame for trigger to frame protocol measurement.
Automatic measurements