Jitter analysis and clock data recovery
R&S
®
RTP
1018User Manual 1337.9952.02 ─ 12
... ... ...
N periods N periods
T
Ncycle1
T
Ncycle2
ΔT
Ncycle1
= T
Ncycle2
- T
Ncycle1
Remote command:
MEASurement<m>:JITTer:NCYCles on page 2258
18.1.2.3 Data measurement settings
The following measurements are intended to analyze serial data. The clock can be a
captured clock signal, or it can be recovered from the data signal using one of the
clock recovery algorithms:
●
Time interval error
●
Unit interval
●
Data rate
► To configure a measurement, tap it in the "Active Measurements" list.
Figure 18-1: Settings for time interval error measurement with real clock signal
Figure 18-2: Settings for data rate measurement with software clock recovery
Jitter measurements (Option R&S RTP-K12)
To Next Page
Loading...
