Rohde & Schwarz RTP Series - Page 1369

Remote control commands
R&S
®
RTP
1369User Manual 1337.9952.02 ─ 12
Histogram measurements
WCOunt | WSAMples | HSAMples | HPEak | PEAK | UPEak-
value | LPEakvalue | HMAXimum | HMINimum | MEDian | MAX-
Min | HMEan | HSTDdev | M1STddev | M2STddev | M3STddev |
MKPositive | MKNegative
See Chapter 22.12.7.2, "Histogram measurement",
on page 1404.
Protocol measurements
NONE | AUDio | F2F | T2F | FLDValue | GAP | MBITrate | SBI-
Trate | BIDLe | FCNT | FEC | FER | CFER
Requires option R&S RTP-K5 for type AUDio, or option
R&S RTP-K35.
Example:
See "Simple frequency and amplitude measurement"
on page 1128.
See "Creating and reading histograms" on page 1130
Usage: Query only
MEASurement<m>:RESult:STARt?
[<MeasType>]
MEASurement<m>:RESult:STOP? [<MeasType>]
Return the start and stop times of the specified measurement. The parameter defines
the measurement. If no parameter is specified, the result of the main measurement is
returned. The main measurement is defined using MEASurement<m>:MAIN.
Suffix:
<m>
.
1..10
See "Selection of the measurement group: MEASurement<m>"
on page 1359.
Query parameters:
<MeasType> See MEASurement<m>:RESult:STDDev? on page 1368.
Usage: Query only
MEASurement<m>:RESult:COUNt?
Returns the number of result groups that are returned by MEASure
ment:RESult:ACTual? HAR.
Suffix:
<m>
.
1..10
See "Selection of the measurement group: MEASurement<m>"
on page 1359.
Query parameters:
<MeasType> HAR
The command is only relevant for harmonic search.
Return values:
Number Number of result groups
Automatic measurements