Rohde & Schwarz RTP Series - Page 1745

Remote control commands
R&S
®
RTP
1745User Manual 1337.9952.02 ─ 12
SEARch:TRIGger:ETHernet:FRAMe:CMAX <SearchName>,<CRCPatternMax>
SEARch:TRIGger:ETHernet:FRAMe:CMAX? <SearchName>
Sets the end value of a CRC error condition pattern, if SEARch:TRIGger:ETHernet:
FRAMe:CCONdition is set to INRange or OORange.
Parameters:
<CRCPatternMax> Numeric or string pattern, see Chapter 22.4.6, "Bit pattern
parameter", on page 1148. The string parameter accepts the bit
value X (don't care).
Parameters for setting and query:
<SearchName> String parameter
SEARch:TRIGger:ETHernet:ERRor:SELect <SearchName>,<ErrorCondition>
SEARch:TRIGger:ETHernet:ERRor:SELect? <SearchName>
Defines, whether a search for an error condition shall be activated or not.
Parameters:
<ErrorCondition> ON | OFF
*RST: OFF
Parameters for setting and query:
<SearchName> String parameter
SEARch:TRIGger:ETHernet:ERRor:PREamble <SearchName>,<ErrorPreamble>
SEARch:TRIGger:ETHernet:ERRor:PREamble? <SearchName>
Defines, whether a search for any preamble error shall be activated or not.
Parameters:
<ErrorPreamble> ON | OFF
*RST: ON
Parameters for setting and query:
<SearchName> String parameter
SEARch:TRIGger:ETHernet:ERRor:LENGth <SearchName>,<ErrorLength>
SEARch:TRIGger:ETHernet:ERRor:LENGth? <SearchName>
Defines, whether a search for any word length error (too few or too many bits per word)
shall be activated or not.
Parameters:
<ErrorLength> ON | OFF
*RST: ON
Parameters for setting and query:
<SearchName> String parameter
Protocols