Rohde & Schwarz RTP Series - Page 1761

Remote control commands
R&S
®
RTP
1761User Manual 1337.9952.02 ─ 12
TRIGger<m>:HBTO:ERRor:PREamble <ErrorPreamble>
Enables / disables trigger on preamble error.
Suffix:
<m>
.
1..3
Parameters:
<ErrorPreamble> ON | OFF
*RST: ON
TRIGger<m>:HBTO:ERRor:CRC <ErrorCRC>
Enables / disables trigger on Cyclic Redundancy Check (CRC) error.
Suffix:
<m>
.
1..3
Parameters:
<ErrorCRC> ON | OFF
*RST: ON
TRIGger<m>:HBTO:ERRor:SFD <ErrorSFD>
Enables / disables trigger on start frame delimiter (SFD) error.
Suffix:
<m>
.
1..3
Parameters:
<ErrorSFD> ON | OFF
*RST: ON
22.17.11.3 Decode results
To show the results on the screen, use the following commands:
●
BUS<m>:RESult on page 1549
In all BUS<m>:HBTO:RESult:FRAMe<n>:WORD<o> commands, the suffix <m>
selects the serial bus, suffix <n> selects the frame in the decode table and suffix <o>
selects the word in the selected frame.
BUS<m>:HBTO:RESult:FCOunt?.................................................................................. 1762
BUS<m>:HBTO:RESult:FRAMe<n>:FTYPe?..................................................................1762
BUS<m>:HBTO:RESult:FRAMe<n>:STATe?...................................................................1762
BUS<m>:HBTO:RESult:FRAMe<n>:STARt?...................................................................1763
BUS<m>:HBTO:RESult:FRAMe<n>:STOP?................................................................... 1763
BUS<m>:HBTO:RESult:FRAMe<n>:DESTaddress?........................................................ 1764
BUS<m>:HBTO:RESult:FRAMe<n>:SRCaddress?..........................................................1764
BUS<m>:HBTO:RESult:FRAMe<n>:TYPE?....................................................................1764
BUS<m>:HBTO:RESult:FRAMe<n>:DATA?....................................................................1765
Protocols