Rohde & Schwarz RTP Series - Page 1768

Remote control commands
R&S
®
RTP
1768User Manual 1337.9952.02 ─ 12
SEARch:TRIGger:HBTO:ERRor:PREamble....................................................................1774
SEARch:TRIGger:HBTO:ERRor:CRC............................................................................ 1774
SEARch:TRIGger:HBTO:ERRor:SFD.............................................................................1775
SEARch:TRIGger:HBTO:TYPE <SearchName>,<Type>
SEARch:TRIGger:HBTO:TYPE? <SearchName>
Selects the type of frame to be searched for.
Parameters:
<Type> STARt | MAC | IDLE | ERRor
STARt
Start of frame.
MAC
MAC frame. This frame contains information that define how to
go about transmitting and receiving frames.
IDLE
IDLE frame. This frame is used for clock synchronization.
ERRor
Error frame. Thi frame contains erroneous bits.
*RST: STARt
Parameters for setting and query:
<SearchName>
SEARch:TRIGger:HBTO:DADDress:CONDition <SearchName>,<DestAddrOptor>
SEARch:TRIGger:HBTO:DADDress:CONDition? <SearchName>
Sets the condition for the destination address. You can define an exact value or a value
range.
Parameters:
<DestAddrOptor> EQUal | NEQual | LTHan | LETHan | GTHan | GETHan |
INRange | OORange
EQUal | NEQual | LTHan | LETHan | GTHan | GETHan
Equal, Not equal, Less than, Less or equal than, Greater Than,
Greater or equal than. These conditions require one data pattern
to be set with the corresponding SEARch:TRIGger:HBTO:
DADDress:MIN command.
INRange | OORange
In range/Out of range: set the minimum and maximum value of
the range with SEARch:TRIGger:HBTO:DADDress:MIN and
SEARch:TRIGger:HBTO:DADDress:MAX.
*RST:
EQUal
Parameters for setting and query:
<SearchName>
Protocols