Rohde & Schwarz RTP Series - Page 1927

Remote control commands
R&S
®
RTP
1927User Manual 1337.9952.02 ─ 12
OFF
Checking condition disabled
*RST: OFF
Parameters for setting and query:
<SearchName>
Example:
SEARch:TRIGger:MPHY:SSIC:FRAMe1:FLD1:ENABle ON
Enables searching for the Symbol field of the TSEQ frame.
SEARch:TRIGger:MPHY:SSIC:FRENable "TS1", "Loop"
ON
Enables searching for the Loop field of the TS1 frame.
SEARch:TRIGger:MPHY:SSIC:FRAMe<m>:FLD<n>:ENABle
<SearchName>,<CondEnabler>
SEARch:TRIGger:MPHY:SSIC:FRAMe<m>:FLD<n>:ENABle? <SearchName>
Enables or disables the checking condition for searching a specific data pattern in the
selected field of the selected frame.
Suffix:
<m>
.
*
Specifies the frame number.
<n> *
Specifies the field number within the frame.
Parameters:
<CondEnabler> ON | OFF
ON
Checking condition enabled
OFF
Checking condition disabled
*RST: OFF
Parameters for setting and query:
<SearchName>
Example:
SEARch:TRIGger:MPHY:SSIC:FRAMe1:FLD1:ENABle ON
Enables searching for the Symbol field of the TSEQ frame.
SEARch:TRIGger:MPHY:SSIC:FRENable "TS1", "Loop"
ON
Enables searching for the Loop field of the TS1 frame.
SEARch:TRIGger:MPHY:SSIC:BIT <SearchName>,<Frame>, <Field>, <Bit>
SEARch:TRIGger:MPHY:SSIC:FRAMe<m>:FLD<n>:BIT <SearchName>,<BitState>
SEARch:TRIGger:MPHY:SSIC:FRAMe<m>:FLD<n>:BIT? <SearchName>
Sets the bit state of a field to be searched that only consists of one bit.
Protocols