Measurements
R&S
®
RTP
325User Manual 1337.9952.02 ─ 12
Cu1, Cu2, Cu3, Cu4
The settings for each cursor measurement (or cursor set) are configured on separate
tabs. For each cursor set, a horizontal pair of cursors, a vertical pair of cursors, or both
can be displayed.
Cursor On/Off
Enables the selected cursor measurement.
Remote command:
CURSor<m>:STATe on page 1349
Type
Defines the cursor type to be used for the measurement.
●
Horizontal cursors (Y-cursors)
Horizontal cursors are positioned automatically along the waveform and can be
adjusted manually
●
Vertical cursors (X-cursors)
Both vertical cursor lines are set automatically to the trigger position, and you can
reposition them manually.
●
Both vertical and horizontal cursors (X&Y-cursors)
Horizontal cursors are positioned automatically along the waveform and vertical
cursors are set to the trigger position. You can reposition all cursor lines manually.
Remote command:
CURSor<m>:FUNCtion on page 1350
Source
Defines the source of the cursor measurement. Any of the input signal, math, reference
or XY waveforms can be selected.
Remote command:
CURSor<m>:SOURce on page 1350
Second source, Source 2
Enables and selects a second source for the cursor measurements. If enabled, the
second cursor lines Cx.2 measure on the second source. Using a second source, you
can measure differences between two channels with cursors.
Remote command:
CURSor<m>:USSource on page 1352
CURSor<m>:SSOurce on page 1351
X1 position, X2 position
Defines the position of the vertical cursors.
Remote command:
CURSor<m>:X1Position on page 1353
CURSor<m>:X2Position on page 1353
Y1 position, Y2 position
Defines the position of the horizontal cursor lines. The setting corresponds to the V1
and V2 values in the "Cursor Results" box.
Cursor measurements
To Next Page
Loading...
