Rohde & Schwarz RTP Series - Page 346

Measurements
R&S
®
RTP
346User Manual 1337.9952.02 ─ 12
Figure 8-4: Manual reference level mode, relative level definition
In manual reference level mode with absolute level definition, you define the absolute
values of high and low signal levels or reference levels, and the distances between ref-
erence and signal levels.
Figure 8-5: Manual reference level mode, absolute level definition
Source
Defines the source for which the reference levels are defined. The source can be any
signal input, math or reference waveform.
Remote command:
Source is defined by suffix <m> in "REFLevel" subsystem, see Chapter 22.12.14, "Ref-
erence levels", on page 1429
Mode
Defines whether the reference level is configured manually or automatically.
Remote command:
REFLevel<m>:LDETection on page 1429
Automatic measurements