Protocol analysis
R&S
®
RTP
528User Manual 1337.9952.02 ─ 12
Address OR ← Trigger type
Triggers on one to four address conditions. Each enabled condition requires an exact
address. You can specify:
For each condition to be used, select "Monitor"
●
"OR x" on page 530
●
Adress Type
●
"Address" on page 529
●
R/W bit
Address and data ← Trigger type
Sets the trigger to a combination of address and data condition. You can specify:
●
Adress Type
●
R/W bit
●
"Address" on page 529
●
"Position" on page 530
●
"Data" on page 530
The address conditions are the same as for the "Address" trigger type and "Data"
on page 530.
I²C (option R&S
RTP-K1)
To Next Page
Loading...
