Rohde & Schwarz RTP Series - Page 580

Protocol analysis
R&S
®
RTP
580User Manual 1337.9952.02 ─ 12
If a DBC file is applied, the symbolic search for messages and signal, which are
defined in the DBC file, is available. Symbolic search is an alternative to the other
search criteria, you can either search for symbolic values or for an AND-combination of
the other 5 criteria.
If symbolic search is active, the "Frame type" is automatically set to "Data", and the
"Identifier" is shown for information.
Symbolic
Enables the symbolic search and disables all other search criteria.
Remote command:
SEARch:TRIGger:CAN:SSYMbolic on page 1654
Message
Sets the message to be triggered or searched for.
The setting is used by symbolic trigger and symbolic search. Thus, you always trigger
on and search for the same message if symbolic trigger and symbolic search is used at
the same time.
Remote command:
SEARch:TRIGger:CAN:SYMBolic:MSGValue on page 1655
Search signals
Enables the search for a specific signal value that is part of the selected message.
Remote command:
SEARch:TRIGger:CAN:SYMBolic:SSIGnals on page 1655
CAN and CAN FD (option R&S
RTP-K3/K9)