Rohde & Schwarz RTP Series - Page 596

Protocol analysis
R&S
®
RTP
596User Manual 1337.9952.02 ─ 12
Remote command:
SEARch:TRIGger:LIN:IDOR<m>:ENABle on page 1675
SEARch:TRIGger:LIN:IDOR<m>[:VALue] on page 1675
Error Condition
Selects the error type to be searched for. You can select one or more error types as
search condition.
The error types are the same as in the LIN trigger setup, see "Error conditions"
on page 592.
Remote command:
SEARch:TRIGger:LIN:IPERror on page 1678
SEARch:TRIGger:LIN:SYERror on page 1678
SEARch:TRIGger:LIN:CHKSerror on page 1678
SEARch:TRIGger:LIN:ERRPattern on page 1679
SEARch:TRIGger:LIN:CRCDatalen on page 1679
SEARch:TRIGger:LIN:STANdard on page 1679
13.6.5.2 LIN search results
To get search results, "Enable" the search. You can minimize, shift or close the search
dialog.
The search results are listed in the search result table and marked in the waveform by
blue lines.
For an introduction to search results, see:
●
Chapter 11.1.2, "Search results", on page 449
●
Chapter 11.4.2, "Display zoom settings", on page 468
Remote commands:
●
SEARch:RESult:LIN:FCOunt? on page 1680
●
SEARch:RESult:LIN:FRAMe<m>:STATus? on page 1680
●
SEARch:RESult:LIN:FRAMe<m>:STARt? on page 1680
●
SEARch:RESult:LIN:FRAMe<m>:STOP? on page 1681
●
SEARch:RESult:LIN:FRAMe<m>:DATA? on page 1681
●
SEARch:RESult:LIN:FRAMe<m>:SDATa? on page 1681
●
SEARch:RESult:LIN:FRAMe<m>:SDEXport? on page 1682
●
SEARch:RESult:LIN:FRAMe<m>:CSSTate? on page 1682
●
SEARch:RESult:LIN:FRAMe<m>:CSValue? on page 1682
●
SEARch:RESult:LIN:FRAMe<m>:IDSTate? on page 1683
●
SEARch:RESult:LIN:FRAMe<m>:IDValue? on page 1683
●
SEARch:RESult:LIN:FRAMe<m>:IDPValue? on page 1683
●
SEARch:RESult:LIN:FRAMe<m>:SYMBol? on page 1684
●
SEARch:RESult:LIN:FRAMe<m>:SYSTate? on page 1684
●
SEARch:RESult:LIN:FRAMe<m>:VERSion? on page 1684
LIN (option R&S
RTP-K3)