Getting started
R&S
®
RTP
64User Manual 1337.9952.02 ─ 12
By default, the diagram name contains the diagram number and the short names of the
waveforms shown inside. To change the diagram name, touch and hold the tab name.
The on-screen keyboard opens to enter the new name. Names must be unique.
To arrange the diagrams on the screen, the Rohde & Schwarz SmartGrid function
helps you to find the target place simply and quickly. For details, see Chapter 3.3.5,
"Rohde & Schwarz smartgrid", on page 71. You can also adjust the diagram size by
dragging the diagram border.
Grid
The grid shows the vertical and horizontal divisions. The division lines are labeled with
the correspondent values. The grid labels have the color of the waveform to which they
belong. If several waveforms are shown in one diagram, the grid has the color of the
selected waveform.
Trigger position and trigger level
The blue markers show the horizontal position of the trigger and the vertical trigger
level. You can touch and move the trigger markers in the diagram to set the positions.
The trigger point is the zero point of the diagram.
The trigger position can be moved outside the diagram. A red trigger position marker
indicates that the trigger position is not visible.
Trigger, Horizontal, Acquisition
The "Trigger", "Horizontal" and "Acquisition" labels show the main timebase and trigger
settings. If you tap a label, the relevant dialog box opens.
Figure 3-4: Trigger label on the toolbar
1 = Trigger source
2 = Trigger type
3 = Trigger level
4 = Trigger mode
5 = Trigger state
6 = Trigger slope
Figure 3-5: Horizontal label on the toolbar
1 = Time scale
2 = Horizontal position
Operating the instrument
To Next Page
Loading...
