Rohde & Schwarz RTP Series - Page 7

Contents
R&S
®
RTP
7User Manual 1337.9952.02 ─ 12
5.7.2 ZVC voltage settings................................................................................................... 198
5.7.3 ZVC current settings................................................................................................... 199
5.8 Differential signals.................................................................................................... 202
5.8.1 Settings of differential signals......................................................................................203
5.8.2 Vertical setup of differential signals.............................................................................205
5.8.3 Deembedding of differential signals............................................................................ 206
5.8.4 Analysis of differential signals..................................................................................... 206
5.9 Setting up the waveform.......................................................................................... 207
5.9.1 Adjusting passive probes............................................................................................ 207
5.9.2 Setting up the signal input with autoset.......................................................................208
5.9.3 Adjusting the signal input manually.............................................................................208
5.9.4 Setting the acquisition................................................................................................. 208
5.9.5 Starting and stopping acquisition................................................................................ 209
5.9.6 Using the roll mode..................................................................................................... 210
5.9.7 Using fast segmentation..............................................................................................210
6 Triggers............................................................................................... 211
6.1 Basics of triggering...................................................................................................211
6.2 Setting up the trigger................................................................................................212
6.2.1 Configuring a simple trigger........................................................................................ 212
6.2.2 Positioning the trigger................................................................................................. 213
6.2.3 Using holdoff............................................................................................................... 213
6.2.4 Setting up an A → B → R trigger sequence..................................................................213
6.2.5 Qualifying the trigger................................................................................................... 214
6.3 Trigger types..............................................................................................................214
6.3.1 Basic trigger settings...................................................................................................215
6.3.2 Edge............................................................................................................................217
6.3.3 Glitch........................................................................................................................... 218
6.3.4 Width........................................................................................................................... 219
6.3.5 Runt.............................................................................................................................220
6.3.6 Window....................................................................................................................... 222
6.3.7 Timeout....................................................................................................................... 223
6.3.8 Interval........................................................................................................................ 224
6.3.9 Slew rate..................................................................................................................... 226