Rohde & Schwarz RTP Series - Page 718

Protocol analysis
R&S
®
RTP
718User Manual 1337.9952.02 ─ 12
BUS<m>:MPHY:DTWO:SOURce on page 1875
BUS<m>:MPHY:DTHRee:SOURce on page 1875
Threshold setup
Opens a dialog, where you can set the tresholds for digitization of signals for each
lane.
"Thresholds"
Enter individual values for each line directly in the fields.
"Couple
thresholds"
Enables the same threshold value for all lanes.
"Find thresh-
olds"
Executes the measurement of reference levels and sets the thresh-
olds to the middle reference level of the measured amplitude.
"Show thresh-
olds"
If enabled, the threshold levels are displayed in the diagram.
Remote command:
BUS<m>:MPHY:DZERo:THReshold on page 1875
BUS<m>:MPHY:DONE:THReshold on page 1875
BUS<m>:MPHY:DTWO:THReshold on page 1875
BUS<m>:MPHY:DTHRee:THReshold on page 1875
BUS<m>:MPHY:THCoupling on page 1876
Scrambled Mode
Available, if "Variant" = "SSIC".
Selects, if the SSIC data is scrambled or descrambled. Set this parameter according to
your signal parameters, to ensure a proper decoding.
Remote command:
BUS<m>:MPHY:SCRMode on page 1876
M-PHY and USB SSIC (option R&S
RTP-K44 and K64)