Rohde & Schwarz RTP Series - Page 738

Protocol analysis
R&S
®
RTP
738User Manual 1337.9952.02 ─ 12
TC
Sets the specified Traffic Class (TC) to be searched for.
TC is used for classifying the traffic flow based on protocol and port number, e.g. TC0
and TC1 are two priority classes with guaranteed link reliability defined and used in L2.
"Data"
Defines the bit pattern of the TC pattern.
In binary format, use the following characters: 1; 0; or X (do not care).
To enter the pattern in other formats use the bit pattern editor, see
Chapter 13.1.7, "Bit pattern editor", on page 519.
Remote command:
SEARch:TRIGger:MPHY:TC on page 1906
Data
Sets the specified data to be searched for. The data setup consists of the condition and
one or two data patterns.
"Condition"
Defines the operator to set a specific data, e.g. "Equal" or "Not
Equal") or a range.
"Data Min/Data"
Defines the bit pattern of the data pattern.
In binary format, use the following characters: 1; 0; or X (do not care).
To enter the pattern in other formats use the bit pattern editor, see
Chapter 13.1.7, "Bit pattern editor", on page 519.
"Data Max"
The second data pattern is required to specify a range with conditions
"In range" and "Out of range".
Remote command:
SEARch:TRIGger:MPHY:DATA:DCONdition on page 1906
SEARch:TRIGger:MPHY:DATA:DMIN on page 1906
SEARch:TRIGger:MPHY:DATA:DMAX on page 1907
Index
Index sets the range within this series of data that is considered for the search. The
index setup consists of the condition and one or two data index values.
"Condition"
Defines the operator to set a specific index, e.g. "Equal" or a range.
"Index Min/Index"
Defines the bit pattern of the index pattern.
In binary format, use the following characters: 1; 0; or X (do not care).
To enter the pattern in other formats use the bit pattern editor, see
Chapter 13.1.7, "Bit pattern editor", on page 519.
"Index Max"
The second index pattern is required to specify a range with condi-
tions "In range".
Remote command:
SEARch:TRIGger:MPHY:DATA:ICONdition on page 1907
SEARch:TRIGger:MPHY:DATA:IMIN on page 1907
SEARch:TRIGger:MPHY:DATA:IMAX on page 1908
M-PHY and USB SSIC (option R&S
RTP-K44 and K64)