Rohde & Schwarz RTP Series - Page 742

Protocol analysis
R&S
®
RTP
742User Manual 1337.9952.02 ─ 12
Remote command:
SEARch:TRIGger:MPHY:ERRor:LENGth on page 1915
13.14.5.2 M-PHY search results
To get search results, "Enable" the search. You can minimize, shift or close the search
dialog.
The search results are listed in the search result table and marked in the waveform by
blue lines.
For an introduction to search results, see:
●
Chapter 11.1.2, "Search results", on page 449
●
Chapter 11.4.2, "Display zoom settings", on page 468
Remote commands:
●
SEARch:RESult:MPHY:FCOunt? on page 1915
●
SEARch:RESult:MPHY:FRAMe<m>:CCOunt? on page 1915
●
SEARch:RESult:MPHY:FRAMe<m>:CELL<n>:DATA? on page 1916
●
SEARch:RESult:MPHY:FRAMe<m>:CELL<n>:TYPE? on page 1916
●
SEARch:RESult:MPHY:FRAMe<m>:CELL<n>:STARt? on page 1916
●
SEARch:RESult:MPHY:FRAMe<m>:CELL<n>:STOP? on page 1917
●
SEARch:RESult:MPHY:FRAMe<m>:CELL<n>:STATe? on page 1917
●
SEARch:RESult:MPHY:FRAMe<m>:DATA? on page 1917
●
SEARch:RESult:MPHY:FRAMe<m>:FTYPe? on page 1918
●
SEARch:RESult:MPHY:FRAMe<m>:STARt? on page 1919
●
SEARch:RESult:MPHY:FRAMe<m>:STATe? on page 1919
●
SEARch:RESult:MPHY:FRAMe<m>:STOP? on page 1920
13.14.5.3 Searching M-PHY
Prerequisite: A serial bus is configured for the M-PHY signal to be decoded and ana-
lyzed.
The search for events is set up in the following way:
1. Press [Search] or tap "Search" > "Setup" in the menu bar.
2. If the dialog box does not contain a search entry, tap the "Add" icon to create one,
as described in "To create a user-defined search" on page 463.
3. Specify the search criteria according to Chapter 13.14.5.1, "M-PHY search setup",
on page 735.
4. To acquire a waveform, press [Single].
The R&S RTP performs an M-PHY decode according to the thresholds and proto-
col settings of the associated serial bus source.
M-PHY and USB SSIC (option R&S
RTP-K44 and K64)