Rohde & Schwarz RTP Series - Page 839

Protocol analysis
R&S
®
RTP
839User Manual 1337.9952.02 ─ 12
At this tab, you can enable and define the equalization techniques used for the equali-
zation at the reciever side of the signal.
CTLE
Continuous time linear equalization (CTLE) is an equalization that can be used for
improving the signal performance. It boosts the high frequency noise and the signal.
Thus it helps reduce the inter-symbol interference (ISI) on the reciever side.
Enable ← CTLE
Enables the CTLE equalization.
Remote command:
BUS<m>:CTLE:ENBLe on page 2046
Zero frequency (fz) ← CTLE
Sets the zero frequency for the transfer function of the CTLE algorithm.
Remote command:
BUS<m>:CTLE:Z1FReq on page 2047
Pole frequency (wp1)/(wp2) ← CTLE
Sets the pole 1/2 frequency for the transfer function of the CTLE algorithm.
Remote command:
BUS<m>:CTLE:P1FReq on page 2046
BUS<m>:CTLE:P2FReq on page 2047
DC Gain (A
DC
) ← CTLE
Sets the adjustable DC gain. This value can be chosen according to the channel loss
characteristics. For low-loss channels, you can set a value close to 0 dB.
USB 3.1 (option R&S
RTP-K61/K62)