Rohde & Schwarz RTP Series - Page 851

Protocol analysis
R&S
®
RTP
851User Manual 1337.9952.02 ─ 12
Make sure that the tab of the correct serial bus is selected.
See also: Chapter 13.1.1, "Setup - general settings", on page 512
Data
Defines the source settings for the data signal. You can select analog channels "C1" to
"C4", and also active math and reference waveforms as source. If you want to trigger
on the serial bus, analog channel sources are required.
Remote command:
BUS<m>:USBPd:SOURce on page 2082
vData
Sets the threshold value of the data.
Remote command:
BUS<m>:USBPd:THReshold on page 2082
Hysteresis
Sets a value for the hysteresis of the data.
Remote command:
BUS<m>:USBPd:HYSTeresis on page 2082
USBPD (option R&S
RTP-K63)