Pulse source and TDR/TDT analysis (option R&S RTP-B7/K130)
R&S
®
RTP
995User Manual 1337.9952.02 ─ 12
Figure 16-3: Channel setup for differential TDR/TDT
Channel
Select the input channels that are connected to the "Ref" connector and the "Out" con-
nector of the pulse source.
For differential measurements, connect also and .
Note: The position of the DUT is shown for information only. Do not connect the DUT.
Remote command:
TDRT:PULSe:OUT on page 2244
TDRT:PULSe:REFerence on page 2244
TDRT:PULSe:INVout on page 2245
TDRT:PULSe:INVReference on page 2245
16.2.3.3 Calibration
Access: [App Cockpit]> "Analysis" > "TDR / TDT" > "Calibrate setup" > "Next"
TDR/TDT analysis (option R&S
RTP-K130)
To Next Page
Loading...
