Scanlab RTC6 PCIe Board - Page 513

RTC6 boards
Doc. Rev. 1.0.21 en-US
10 RTC6 Commands
513
innovators for industry
Comments
(cont’d)
• If Name is NULL, then load_stretch_table disables any enhanced 3D correction enabled
by a previous load_stretch_table.
• load_stretch_table is not executed (get_last_error return code RTC6_BUSY ), if:
– the BUSY list execution status is set
– the INTERNAL-BUSY list execution status is set
• load_stretch_table is even executed, if:
– a list has been paused by set_wait (PAUSED list execution status set)
• During execution of load_stretch_table, External Starts are suppressed.
• Before loading a table, load_stretch_table performs a DSP memory check that
produces error code 4 in case of error.
RTC4RTC6 New command.
RTC5RTC6 Changed functionality.
• Additional TableNo parameter. This allows that each 3D correction table can be
assigned its own extended 3D correction.
Version info Available as of DLL 600, OUT 600, RBF 600.
References select_cor_table
Ctrl Command load_stretch_table