Scanlab RTC6 PCIe Board - Page 801

RTC6 boards
Doc. Rev. 1.0.21 en-US
10 RTC6 Commands
801
innovators for industry
Ctrl Command store_timestamp_counter
Function Saves the current 32-bit “Timestamp Counter” value.
Call store_timestamp_counter()
Parameters None.
Comments • See Chapter 8.12 ”Time Measurements”, page 281.
• The current 32-bit “Timestamp Counter” value is stored as time reference
TimeStampStorage
for wait_for_timestamp_counter.
RTC4RTC6 New command.
RTC5RTC6 New command.
Version info Available as of DLL 617, OUT 617, RBF 623.
References store_timestamp_counter_list, wait_for_timestamp_counter
Undelayed
Short List
Command
store_timestamp_counter_list
Function Like store_timestamp_counter, but a list command.
Call store_timestamp_counter_list()
Parameters None.
Comments • See store_timestamp_counter.
RTC4RTC6 New command.
RTC5RTC6 New command.
Version info Available as of DLL 617, OUT 617, RBF 623.
References store_timestamp_counter, wait_for_timestamp_counter