Scanlab RTC6 PCIe Board - Page 913

RTC6 boards
Doc. Rev. 1.0.21 en-US
16 Appendix A: The RTC6 Ethernet Board
913
innovators for industry
Table 8: Control commands allowed for automatic booting (alphabetically)
Boot Phase 1
bounce_supp
config_laser_signals
config_list
eth_boot_timeout
eth_set_remote_tgm_format
home_position
home_position_xyz
mcbsp_init
set_control_mode
set_extstartpos
set_free_variable
set_jump_mode
set_laser_control
set_laser_mode
set_matrix( HeadNo = 4 )
set_max_counts
set_mcbsp_freq
set_mcbsp_out_ptr
set_offset_xyz( HeadNo = 4 )
set_pulse_picking_length
set_rot_center
set_scanahead_params
set_scanahead_
speed_control
set_timelag_compensation
simulate_encoder
uart_config
Boot Phase 2
control_command
init_fly_2d
select_cor_table
set_auto_laser_control
set_dsp_mode
set_hi
start_loop