ST STM32F102 series User Manual

RM0008 DMA controller (DMA)
145/690
9.4.4 DMA channel x number of data register (DMA_CNDTRx) (x = 1 ..7)
Address offset: 0x0C + 20d × Channel number
Reset value: 0x0000 0000
Bit 4 DIR: Data transfer direction
This bit is set and cleared by software.
0: Read from peripheral
1: Read from memory
Bit 3 TEIE: Transfer error interrupt enable
This bit is set and cleared by software.
0: TE interrupt disabled
1: TE interrupt enabled
Bit 2 HTIE: Half transfer interrupt enable
This bit is set and cleared by software.
0: HT interrupt disabled
1: HT interrupt enabled
Bit 1 TCIE: Transfer complete interrupt enable
This bit is set and cleared by software.
0: TC interrupt disabled
1: TC interrupt enabled
Bit 0 EN: Channel enable
This bit is set and cleared by software.
0: Channel disabled
1: Channel enabled
Bits 31:16 Reserved, always read as 0.
Bits 15:0 NDT[15:0]: Number of data to transfer
Number of data to be transferred (0 up to 65535). This register can only be written when the channel
is disabled. Once the channel is enabled, this register is read-only, indicating the remaining bytes to
be transmitted. This register decrements after each DMA transfer.
Once the transfer is completed, this register can either stay at zero or be reloaded automatically by
the value previously programmed if the channel is configured in auto-reload mode.
If this register is zero, no transaction can be served whether the channel is enabled or not.

ST STM32F102 series Specifications

General

Brand	ST
Model	STM32F102 series
Category	Microcontrollers
Language	English