RM0008 Controller area network (bxCAN)
499/690
21 Controller area network (bxCAN)
Low-density devices are STM32F101xx, STM32F102xx and STM32F103xx
microcontrollers where the Flash memory density ranges between 16 and 32 Kbytes.
Medium-density devices are STM32F101xx, STM32F102xx and STM32F103xx
microcontrollers where the Flash memory density ranges between 64 and 128 Kbytes.
High-density devices are STM32F101xx and STM32F103xx microcontrollers where the
Flash memory density ranges between 256 and 512 Kbytes.
This section applies to the STM32F103xx performance line family only.
21.1 Introduction
The Basic Extended CAN peripheral, named bxCAN, interfaces the CAN network. It
supports the CAN protocols version 2.0A and B. It has been designed to manage a high
number of incoming messages efficiently with a minimum CPU load. It also meets the
priority requirements for transmit messages.
For safety-critical applications, the CAN controller provides all hardware functions for
supporting the CAN Time Triggered Communication option.
21.2 bxCAN main features
● Supports CAN protocol version 2.0 A, B Active
● Bit rates up to 1 Mbit/s
● Supports the Time Triggered Communication option
Transmission
● Three transmit mailboxes
● Configurable transmit priority
● Time Stamp on SOF transmission
Reception
● Two receive FIFOs with three stages
● 14 scalable filter banks/CAN cell - shared between CAN cells
● Identifier list feature
● Configurable FIFO overrun
● Time Stamp on SOF reception
Time-triggered communication option
● Disable automatic retransmission mode
● 16-bit free running timer
● Configurable timer resolution
● Time Stamp sent in last two data bytes
To Next Page
Loading...
