INTRODUCTION, LCD Screen
1-12 Sysmex SF-3000 Operator's Manual -- Revised September 1995
SU : Indicates the status of the Sampler Unit.
No indication : The Sampler Unit is not connected.
SU : Sampler Unit ready for sampler analysis.
SU (with red back-light) : Sampler not operational because of abnormality
in Sampler Unit.
CP : Indicates the status of the Manual Cap Piercing (CP) Unit.
No indication : The Manual CP Unit is not connected.
CP : Manual CP Unit ready for manual closed mode
analysis.
CP (with red back-light) : Manual closed mode not operational because of
abnormality in Manual CP Unit.
ID : Indicates the status of the ID Bar Code Reader.
No indication : The Bar Code Reader is set to "Not
Connected".
ID : The Bar Code Reader is ready.
ID (with red back-light) : "ID Unit Com. Error" has occurred between
SF-3000 and Bar Code Reader.
HD (with green backlight) : Appears when the system hard disk is being accessed.
• Function Keys
The [Sysmex] and [Sampler] keypads appear at each end of this area.
[Sysmex] -- Press this key to obtain the hard copy of screen and to access the Error Log.
Refer to Section 9.3 in this chapter for hard copy output. Refer to Chapter 8:
Troubleshooting for Error Log.
When an error occurs, this key changes to [Alarm Reset] with red backlight. Press to
stop the alarm.
[Sampler] -- Press to display the sampler start check window, where the Sample ID No.,
Rack No. and Tube Position No. for the next auto mode analysis can be set up. This
keypad changes to [Sampler Stop] during auto mode analysis.
2 . Data Processing Area
Analysis and sample information, including analysis data, scattergrams, cell size
distributions, QC menus, action messages, sub-program menu keypads, etc. are
displayed in the center area of the display screen.
To Next Page
Loading...
