SYSMEX SF-3000 User Manual

INTRODUCTION
Sysmex SF-3000 Operator's Manual -- Revised September 1995 1-19
13. INSTALLATION REQUIREMENTS
13.1 Relocation Information
The SF-3000 and associated equipment should only be installed by your Sysmex service
representative. Contact your Sysmex service representative if relocation of the system is
required after it has been installed.
NOTE: Problems resulting from the relocation of the SF-3000 by anyone other
than a Sysmex service representative are not covered by the
Warranty.
The service agreement covers moving the SF-3000 after the warranty period has expired.
13.2 Electrical Requirements
The SF-3000 comes equipped with a three-prong or two-prong plug power cord. The
type of cord and plug supplied depends on the source voltage for the system.
Figure 1-8: 117 VAC Plug Figure 1-9: 220 VAC Plug Figure 1-10: 240 VAC Plug
WARNING!: Proper use of the appropriate power cord assures adequate grounding
for the system. Failure to properly ground the SF-3000 bypasses
important safety features and may result in an electrical hazard.
The power source required for the SF-3000 system is: 117, 220 or 240 VAC ± 10%,
50/60 Hz.
The power consumption of the system, including the Pneumatic Unit and Sampler Unit,
is 600 VA or less.

SYSMEX SF-3000 Specifications

General

Brand	SYSMEX
Model	SF-3000
Category	Measuring Instruments
Language	English