SYSMEX SF-3000 User Manual

TROUBLESHOOTING
8-68 Sysmex SF-3000 Operator's Manual -- Revised September 1995
4 . Reaction Chamber Mixing Motor
This program performs test operation of the Reaction Chamber Mixing Motor and
displays the rotation speed of the motor. Run this test if a "Mixing Motor Speed Error"
occurs and analysis cannot be performed. If the test corrects the error, analysis will be
possible after the system enters the Ready mode.
(1) Open the front cover and set the stop bar in place.
WARNING! When working with the front cover open, make sure that the stop bar
is in place to avoid accidental closure.
(2) Bring the Test screen by pressing [Mainte.] and then [Test] keypads (Refer to
Section 3.1 in this chapter).
(3) Press the [Mixing Motor] keypad from the Test screen. The message "Press Start
Switch" will appear.
(4) Press the Start Switch. Mixing motor operation will begin and the rotation speed
will be displayed and updated every 2.4 seconds. Check if the rotation speed is
stable within the normal range of 1600 - 2000 rpm.
Return
SRV
WB Motor
Sheath Motor
Rinse Motor
Mixing Motor
PDA
ID Read
DP Print
GP Print
Sysmex
DP:1234567890123 XM HC GP DP SU
Running Test Mode Next No.1234567890123
Sampler
< Test >
Laser
Cancel
Executing Mixing Motor test.
1850 rpm
Sampler CP Mech.
Touch Panel
Rack Feed In Memory HOST Interface
Maintenance
Figure 8-12: Mixing Motor Operation Speed
(5) Press [Cancel] to end the Mixing Motor test program.
(6) Press [Return] to end the Test program.

SYSMEX SF-3000 Specifications

General

Brand	SYSMEX
Model	SF-3000
Category	Measuring Instruments
Language	English