SYSMEX SF-3000 User Manual

TROUBLESHOOTING
8-76 Sysmex SF-3000 Operator's Manual -- Revised September 1995
3.9 Test Floppy Disk
Use this program to test writing and reading of data to and from the floppy disk.
(1) Bring the Test screen by pressing [Mainte.] and then [Test] keypads (Refer to
Section 3.1 in this chapter).
(2) Press the [Floppy Disk] keypad from the Test screen. The message "Insert Floppy
Disk." will appear.
Sysmex
DP:1234567890123
XM HC GP DP SU
Ready Test Mode Next No.1234567890123
Sampler
Maintenance
< Test >
SRV
WB Motor
Sheath Motor
Rinse Motor
Mixing Motor
PDA
Rack Feed In
Rack Shift
Rack Feed Out
Sampler CP Mech.
ID Read
Memory
Floppy Disk
LCD Display
Touch Panel
DP Print
GP Print
HOST Interface
Laser
Return
< Floppy Disk Test >
OK
Insert Floppy Disk.
Cancel
Figure 8-20: Insert FD Window
(3) Insert a pre-formatted floppy disk into the floppy disk drive.
NOTE: A floppy disk can be formatted using "Mainte." - "Format FD" program.
Refer to Chapter 5, Section 10: Format FD .
(4) If the disk is normal, the display will return to the previous screen.

SYSMEX SF-3000 Specifications

General

Brand	SYSMEX
Model	SF-3000
Category	Measuring Instruments
Language	English