TROUBLESHOOTING
8-80 Sysmex SF-3000 Operator's Manual -- Revised September 1995
3.12 Test Output
Following 3 programs are provided to test the output to the printers and/or host
computer.
• DP Print • GP Print • Host Interface
1 . DP (Data Printer) Print
Use this program to test the Data Printer. (The data printer is tested using the currently
set print format.)
(1) Bring the Test screen by pressing [Mainte.] and then [Test] keypads (Refer to
Section 3.1 in this chapter).
(2) Press the [DP Print] keypad from the Test screen. The Data Printer will print out a
dummy data.
Figure 8-23: DP Test Print Example
To Next Page
Loading...
