TROUBLESHOOTING
Sysmex SF-3000 Operator's Manual -- Revised September 1995 8-81
2 . GP (Graphic Printer) Print
Use this program to test the Graphic Printer or Line Printer. (The printer is tested using
the currently set print format.)
(1) Bring the Test screen by pressing [Mainte.] and then [Test] keypads (Refer to
Section 3.1 in this chapter).
(2) Press the [GP Print] keypad from the Test screen. The Graphic Printer will print
out a dummy data.
Figure 8-24: GP Test Print Example
NOTE: Scattergrams are not printed.
Sysmex SF-3000 Operator's Manual -- Revised October 1995
To Next Page
Loading...
