SYSMEX SF-3000 - Page 403

TROUBLESHOOTING
8-82 Sysmex SF-3000 Operator's Manual -- Revised September 1995
3 . HC (Host Computer) Output
Use this program to test the interface with the Host Computer by transmitting a dummy
data to the Host Computer.
(1) Bring the Test screen by pressing [Mainte.] and then [Test] keypads (Refer to
Section 3.1 in this chapter).
(2) Press the [HOST Interface] keypad from the Test screen. A dummy data will be
transmitted to the Host Computer.
HC Test Dummy Data (234 bytes including STX and ETX)
D1U05259500000000000 TEST PRINT00000000000000000
00111110222203333044440555506666077770888801111022
22033330444405555099999011111022222033333044444077
77088880444405555066660000000000000000000000000000
00000000000000000000000000000000
Figure 8-25: Host Computer Output Example