SYSMEX SF-3000 - Page 405

TROUBLESHOOTING
8-84 Sysmex SF-3000 Operator's Manual -- Revised September 1995
Sysmex
DP:1234567890123
XM HC GP DP SU
Ready
Manual Mode Next No.1234567890123
Sampler
Quit
Main Unit
Loader
D-I/O
Sampler Unit
SET VALUE
[ 1SF32 Ver. 00-05 ]
[ 2SF31 Ver. 00-01 ]
[ 3SF31 Ver. 00-00 ]
[ 4SF31 Ver. 00-09 ]
READ VALUE
[ 1SF32 Ver. 00-05 ]
[ 2SF31 Ver. 00-01 ]
[ 3SF31 Ver. 00-00 ]
[ 4SF31 Ver. 00-09 ]
Complete
Complete
Complete
Complete
Set
Set
Set
Set
Figure 8-28: Version Check Screen
(Actual values displayed on your system may vary from these values.)
(3) Press [Quit] to end the Version Check program.
(4) If the read values do not match to the set values, in case when the program version
has been updated, "Error" appears on the right of the corresponding value.
(5) Verify that the program version displayed in READ VALUE column is correct, and
press [Quit]. The version check confirmation window will appear.
Pressing [Set] registers the read check sum values as new set values.
Pressing [Cancel] ends the program without updating the check sum values.
Pressing [Continue] returns to the version check screen.
Sysmex
DP:1234567890123
XM HC GP DP SU
Ready
Manual Mode Next No.1234567890123
Sampler
Main Unit
Loader
D-I/O
Sampler Unit
SET VALUE
[ 1SF32 Ver. 00-05 ]
[ 2SF31 Ver. 00-01 ]
[ 3SF31 Ver. 00-00 ]
[ 4SF31 Ver. 00-09 ]
READ VALUE
[ 1SF32 Ver. 00-05 ]
[ 2SF31 Ver. 00-01 ]
[ 3SF31 Ver. 00-00 ]
[ 4SF31 Ver. 00-09 ]
Complete
Complete
Complete
Complete
Execute settings.
Continue
CancelSet
Quit
Set
Set
Set
Set
Figure 8-29: Version Check Confirmation Window