SYSMEX SF-3000 User Manual

SAMPLE PROCESSING, Auto Mode Procedures
2-34 Sysmex SF-3000 Operator's Manual -- Revised September 1995
3 . Analyze Sample
(1) Put the sample tubes in the rack, and set
the rack in the right rack pool of the
sampler. Each rack holds up to 10
sample tubes.
(2) Press the [Start] key in the Sampler
Start Check window. The instrument
performs mixing, aspirating, and
analyzing until all of the samples in a
rack in the right rack pool have been
analyzed.
(3) When all of the racks have moved to the
left rack pool of the sampler, the
READY LED turns on.
Figure 2-25: Load Racks on the
Sampler
CAUTION: Do not remove the cover from the Piercer Unit during sampler
operation.
NOTE: • The [Sampler] key alternates with [Sampler Stop] key. During
sampler analysis, [Sampler Stop] key appears.
• If you press the [Sampler Stop] key during sampler analysis, the
sampler stops and stat (manual) analysis can be performed.
After the sample is aspirated, the analysis begins. You can check the status of each stage
of analysis using the Analysis Process screen. To see this screen, press [Status] key in
the root menu. Switch to "P2. Analysis Process" using the [→] and [←] keys.
←
Sysmex
DP:1234567890123
XM HC GP DP SU
Ready
Auto Mode Next No.1234567890123
Sampler
STATUS
< Analysis Process >
Sequence
ID No.
Rack
Aspirate
Dilute
RBC Count
WBC/BASO Count
DIFF Count
RBC Analyze
WBC/BASO Analyze
DIFF Analyze
Edit
Store
13
123-567-90123
1001-3
12
123-567-90122
1001-2
11
123-567-90121
1001-1
10
123-567-90120
1000-10
: Entry
: Interruption
: Run
: Finish Abnormal
: Finish Normal
→ Return
Figure 2-26: Analysis Process Screen (Auto Mode)

SYSMEX SF-3000 Specifications

General

Brand	SYSMEX
Model	SF-3000
Category	Measuring Instruments
Language	English