SAMPLE PROCESSING, Manual Closed Mode Procedures
Sysmex SF-3000 Operator's Manual -- Revised September 1995 2-39
3 . Input Sample ID Number
Using the Sample No. Setting Screen, input the next sample ID number to be analyzed as
described below, if needed.
(1) The next sample number to the previously analyzed sample in Closed mode appears
above the numerical keys. Clear the number by pressing [C] key and input the
sample ID number with the numerical keys, if needed.
NOTE: When the next sample No. is not set, or after the power ON, the next
sample No. is automatically set to No. 1, increasing by 1 for each
succeeding sample (e.g., 1, 2, 3, ...).
(2) Press [ENTER]. The next sample No. is set and the Sample No. Setting screen
will disappear. The input sample No. will be displayed in the Next No. column in
the top line of the LCD.
CAUTION: Do not use zero as the sample ID number. If the ID number is set to
zero, the analysis results will be neither stored nor output. If the
sample I
D number is set to zero, continuous short beeps will sound
during sample aspiration to alert the operator.
NOTE: • The sample ID can include numbers (0-9) and hyphens up to a
maximum of 13 characters.
• Hyphens cannot be placed at the beginning or end of the sample ID
number, nor can two hyphens be placed consecutively.
• A number will not be carried beyond a hyphen. For example, the
number following 2-999 will be 2-000; 1-99-000 will follow 1-99-999.
• The number following 9999999999999 will be 1.
To Next Page
Loading...
Need help?
General
