Tecnam P2002 JF - Page 1016

SUPPLEMENT S2
Chapter 27 – Flight Control
Page 18
2nd Edition – Rev 0
HAND CONTROL INSTALLATION
1) Apply the procedure for removing the mechanical system, in reverse order.
standard torque values for AN3 and AN4 bolts can be used
to secure the hand control components
10-32 = 3Nm
1/4 = 9Nm
POST-INSTALLATION CHECKS
1) Verify that the bolts of mechanical interface (p/n 22-5-445-000) are installed
properly and do not interfere with movement of the system rods;
2) Verify that the two bolts securing the bearing on the cockpit panel are
installed properly;
3) Make sure that the flap connector switch is fastened;
4) Verify the following:
(a) Movement is free and smooth;
(b) The rudder control reaches its maximum travel in both directions;
(c) The throttle control reaches its maximum travel in both directions;
(d) The flap switch is properly functioning when the flap switch selector
is on the "hand control" position;