SUPPLEMENT SG-3
CHAPTER 31 - INDICATIONG SYSTEM
Single LRU Software upload procedure
Additional info
&References
Ensure that power will remain applied to the system.
If GDU620 software has to be installed, press the ENT
key to load new software. Else press CLR key.
All G500 screen shots
used in this document are
intended to provide
visual
reference only. All
information depicted in
screen shots, including
software file names,
versions and part
numbers, is subject to
change and may not be
up to date.
New software is loaded to the GDU620.
When complete, the following message is shown:
Press any soft key to acknowledge the prompt.
This step is valid only if
ENT key is pressed at
previous step.
The GDU620 starts in configuration mode
Go to the “Software Upload” page rotating the knob on
the PFD:
Select the unit whose software has to be installed and
press the LOAD soft key
A prompt like this will be shown to the user:
To Next Page
Loading...
