Tecnam P2002 JF - Page 1094

2
nd
Edition - Rev 0
SUPPLEMENT SG-3
CHAPTER 31 - INDICATIONG SYSTEM
Page 215
Step
no.
Airspeed Markings setup
Additional info
&References
7.
Master switch: ON
8.
GRS breaker: push
9.
GDC breaker: push
10.
While holding the ENT key on the GDU620, restore
power by closing the GDU circuit breaker
11.
When the words appear in
the upper center of the PFD/MFD, release the ENT
key
12.
Ensure that power will remain applied to the system.
If GDU620 software has to be installed, press the
ENT key to load new software. Else press CLR key.
All G500 screen shots
used in this document
are intended to provide
visual
reference only. All
information depicted in
screen shots, including
software file names,
versions and part
numbers, is subject to
change and may not be
up to date.
13.
The GDU620 starts in configuration mode
14.
Turn the small Knob on PFD and select the
AIRFRAME CONFIGURATION page:
15.
Push the button on the small knob and turn the big
knob to scroll the fields until the first speed in the