Tecnam P2002 JF - Page 1265

2
nd
Edition - Rev 0
SUPPLEMENT SG-1
CHAPTER 34 - NAVIGATION
Page 34
Step
no.
Single LRU Software upload procedure
Additional info
&References
14.
The system prompts the user to load the new software
version contained on the loader card in the bottom slot of
GDU620.
All G500 screen
shots used in this
document are
intended to
provide visual
reference only.
All information
depicted in screen
shots, including
software file
names, versions
and part numbers,
is subject to
change and may
not be up to date.
15.
Ensure that power will remain applied to the system.
If GDU620 software has to be installed, press the ENT key
to load new software. Else press CLR key.
All G500 screen
shots used in this
document are
intended to
provide visual
reference only.
All information
depicted in screen
shots, including
software file
names, versions
and part numbers,
is subject to
change and may
not be up to date.
16.
New software is loaded to the GDU620.
When complete, the following message is shown:
Press any soft key to acknowledge the prompt.
This step is valid
only if ENT key
is pressed at
previous step.
17. The GDU620 starts in configuration mode
18.
Go to the “Software Upload” page rotating the knob on the
PFD: