2
nd
Edition - Rev 0
SUPPLEMENT SG-1
CHAPTER 34 - NAVIGATION
Page 35
Step
no.
Single LRU Software upload procedure
Additional info
&References
19.
Select the unit whose software has to be installed and press
the LOAD soft key
20.
A prompt like this will be shown to the user:
Press ENT key to start the software upload.
21.
A progress bar showing the percentage of the upload
process completed is shown:
22.
When the upload procedure is completed an “Upload
complete” message will be shown:
When this message is shown
press the ENT key to
acknowledge the process completion.
23.
Go to the MANIFEST CONFIGURATION page in
the SYS page group. The manifest will be empty on
first use.
1. Wait for the GRS 77, GMU 44 and GDC 74A to
power up.
2. Press the MANIFEST soft key to automatically
populate the manifest.
To Next Page
Loading...
